Wall techniques

From Brickwiki
Jump to: navigation, search

There are many ways of making walls, whether it is for buildings, vehicles, or whatever else.

To create walls, you can simply stack bricks. But you have to respect some principles if you want to obtain some solid and good looking results.

Contents

Basics

Solidity

NCLTC train container showing offset

The higher your wall is the larger bricks you should use. A wall higher than 5 courses(every horizontal layer of bricks) needs to be built using 2xn bricks. Of course, you could build with 1xn bricks if the wall uses structural reinforcement such as buttress.

Another point for solidity is to create an offset between the vertical joint of each course, which Steve Barile has described as "crossing your line" (Quoted by Jake McKee in his book "Starting with LEGO trains").


When using 1xn bricks, in the corner, the 2x2 corner bricks are widely used to perform this offset.

Appearance

NCLTC train container pattern detail

Stacking without offset is used to create decorative shape. For advanced information on appearance, check out wall texturing.

Curved wall

Curved wall with 1x2 bricks

Using 1x2 bricks

If you build a very long wall using only alternated 1x2 bricks, you will notice that you can bend it a little bit because of the room between the bricks. The minimum radius of this wall is quite big (please add the value here if you know it).

Building with curved walls by Denis Huot. Image available under GFDL, supplied by Alban Nanty, 2007

This technique may be considered by certain AFOL as an illegal connection since it stresses the bricks a little.

Curved wall with 1x3 bricks

Using 1x3 bricks

Another technique lets you create a curved wall with a smaller radius. This technique use an alternation of 1x3 bricks and 1x1 rounded bricks. The idea of this technique is to add a small angle by turning on a stud and then add a rounded brick in the hole. The rounded brick remove the stress problem we have with the 1x2 brick curved wall.

You can also use 1x3 plates and 1x1 round plates if you want to make a low wall.

The disadvantage of this technique is that the wall is not perfectly smooth.

Using round bricks

There are also some round bricks that you can use:

  • Brick 2x2 corner round (also called the "macaroni" brick)
  • Panel 4x4x6 corner round

Angled Walls

Sometimes a builder might wish to make a wall that is not at 90 degrees to an adjoining wall but is still straight. This can be achieved using a variety of methods.

Angled Bricks

LEGO produces a number of elements that are sometimes described as modified bricks featuring one face that is at an angle other than 90 degrees. Stacking these bricks cretes a wall surface that features small gaps as the design of the bricks requires small cut outs to allow for the connecting studs to be bridged.

Turntables

A distinctive feature of the Cafe Corner and subsequent sets in the Modular houses standard has been corner walls angled at 45 degrees to the connecting walls. This is achieved by mounting the wall segments on what Peeron describes as Turntable 2 x 2 Plate[1].

Hinges

Hinges can also be used to create a stable angled wall as demonstrated in a video featuring Designer Jamie Berard.


Advanced wall technique

It exist a great variety of pattern for brick walls :

  • Stack bond (Bond : assembly of brick wall)
  • Stretcher bond (Stretcher : long side of the brick faces out)
  • Header bond (Header : short side of the brick faces out)
  • Common bond
  • English bond
  • Flemish bond
  • Wall texturing

External links

Personal tools